Sign in / Sign Up About Us Contact Us info@dentalplaza.co.uk

DESIGN CHARACTERISTICS

Thin magnetostrictive and piezoelectric - left-curved unit investment trusts simulate the size and shape of dental supplies periodontal probes . This design allows consistent access and adaptive root anatomy, and allows clinicians to reach a pocket beyond the base of a depth greater than 4mm and a standard direct unit investment trust. The right and left curvature of 1, 4, 6 is unique and allows access to specific dental surfaces. These particular UITs are used for low to moderate power; However, low power consumption is only used for biofilm removal, not calculus. In moderate intensity, light and non-tenacious stones may be eliminated, while moderate or tenacious residual stones are polished. A left-handed Inuit applies to the upper right maxillary and left mandible cheek, as well as the upper left maxillary and the lower right mandible tongue. A right - curved Inuit is suitable for the upper left upper jaw and lower right jaw, as well as the upper right maxillary tongue and the left lower jaw
When using a right or left bent newt, consider the size or diameter of the UITs. Some of the UITs may be too thick to fit in with healthy and dense tissue, preventing the ability to insert under the gum. The other right and left curved UITs are thinner and can be inserted under the gum, allowing the tip to extend under the contact point. Ultimately, clinicians need to assess and assess whether they can effectively insert and adapt to the selected right and left bent UITs and completely transplant them to the bottom of the pocket.
Selection and sequence
In the initial treatment, patients may have 5mm or larger periodontal pockets, moderate to severe supra - and sub gums soft and hard sediments. In this case, the use of block injection or osmotic local anesthesia is necessary for pain control. The general debridement is the most common standard of direct Inuit in the middle to high strength and multidirectional stroke of the stone in the mouth part of the stone. After most calculations are removed, thin straight and right - and left - bent UITs should be used for low to medium strength to eliminate residual sediment. If the right and left bent UITs are too thick, or if the tissue is too tight to allow entry, consider using a thin, straight newt. While a thin Inuit is not ideal, it may be the only option. During the follow-up, if there is no trace of the bleeding, a mild stroke or low power of a thin, thin, thin newt can be used for painful pain
In cases of routine prevention and periodontal maintenance treatment, patients may have minor or localized dental equipment attachment loss, light to moderate supra - and subgingival biofilms and stones. A standard coliform can be used first to remove local moderate to severe, excessive hard sediments, which are usually found on the surface, as shown below. Then, most dentists will continue to use a thin, pure Inuit, when a combination of a single, straight, right and left UITs is more effective in accessing deep back pockets, furcations, and holes. The right and left bent UITs can be used alone to complete all surfaces of the mouth. However, when using low power UITs, attention should be paid to the risk of polishing. Covering the entire root surface with controllable and overlapping strokes helps reduce the likelihood of grinding stones. All non-surgical periodontal procedures must be activated by hand to complete the remaining stones or radical roots.

Dentalplaza.co.uk is one professional dental supplies website which supplies dental equipment in UK with competitive price and high quality.

Reviews

WRITE REVIEW
This product hasn't received any reviews yet. Be the first to review this products.
  • Email Address:

  • Rank:

  • Content: