1. Connect one end of the water tube to the nozzle of the wet model trimmer and the other end to the tap, open the valve
2. Connect the waste-disposal tube to the unit
3. Connect the power cord, and switch on the power switch (O=off, l=on)
4. When braking, it is normal to hear clicking before the sand tablet stops. If the sand tablet makes unusually loud noises, remove it, and use the included hex-wrench to adjust the screw on the back cover (18)
5. To check if you need to replace the abrasive disk, rotate the disk by hand and estimate: if the platform jumps more than 2mm, change the disk. After replacing the disk, make sure to tighten the ring on the platform 8 (closest to the outside of the sand tablet)
Voltage: <A>220V/50Hz±10% , <B>110V/60Hz±10%
Power: 500W
Rotational Speed: 2800 rpm
Dimensions: 44×35×35cm
Weight of the dental trimmer: 20kg
JT Ball Type Arch Trimmer JT-37 80W with 2 Led Light
As low as: £185.00
Titan P60+ Automatic Programmable Vacuum Porcelain Furnace
As low as: £3200.00
Dental Model 2800rpm Arch Trimmer Trimming sides of plaster ...
As low as: £287.00
Dental Model Trimmer AX-MTA Wet Plaster Model Trimmer 2,800R...
As low as: £459.00
JT Wet Model Trimmer Abrasive Disc Wheel JT-19C
As low as: £435.00
Copyright 2020 dentalplaza.co.uk. All rights reserved.
